|About |Contact | Korean |
type WBCS3000L / WBCS3000Le Series
No switching time (charging to discharging, discharging to charging)
Analog feedback control to keep constant voltage & current
Capability of electrochemical experiments by controlling voltage versus
reference electrode for positive voltage polarity only.
16bit(0.0015% full scale) ADC, DAC
4 current ranges (automatic/manual selection)
Shield cell cable to prevent EMI noise
Unique “Fail check” function: Automatic stop when measured value is different from control value by battery failure or wrong cell connection etc. => To protect system and cell.
E.g. Control value: 1Amp Measured value: 500mA then automatic stop the channel
System safety parameter: If the measured value is over system specification, Automatic stop the running channel
User defined safety condition setting: User can input safety level following test cell’s chemistry.
Automatic cell connection check: Before experiment, if the cell voltage value is near 0Volt, program gives the warning message for the operator to check the cell connection.
If operator did press stop function button by mistake, confirmation message box appears.
To prevent over current, poly-switch is located in each channel
Watchdog function: Stop “running channel(s)” on communication Failure.
While any channel is running, operator could not close the server program
If main program was down by unstable operating system, independent server program keeps the experiment (control & data acquisition) without dead time.
Maintenance & System Expansion
Plug-In type channels(Inside system)
Power supply per 8channel
Easy expansion by adding plug in channel or by adding 8ch substation
Each channel has Poly switch instead of fuse.
Lithium polymer battery jig
Coin cell holder
Low current type channel power limit
Max. current per channel
For higher power
|WonATech | WonA Building 7, Neunganmal 1-gil,SeoChoGu,Seoul,137-180 Korea | Phone:+82-2578-6516 | Fax:+82-2576-2635|